University of Texas at Arlington Grade Calculator

UT Arlington’s official table is brutally flat: A, B, C, D, F — no plus/minus grades and no A+ anywhere — at 4, 3, 2, 1 and 0 grade points per semester hour. An 89 and a 99 both pay 4.0; an 81 and an 89 both pay 3.0. Calculate what you need above.

You can only repeat a course at UTA if your earlier grade was below C, and both attempts are averaged into your GPA unless Grade Forgiveness applies — since Fall 2013, up to two D/F grades in 1000/2000-level courses can be removed (earlier cohorts used Grade Exclusion, max 3 courses).

Calculating…

🎓 Need your GPA instead? Jump to the University of Texas at Arlington GPA calculator (official scale) ↓

UT Arlington grading scale (official)

LetterGrade points
A4.00
B3.00
C2.00
D1.00
F0.00

UTA uses flat letter grades only — no plus/minus grades, no A+ — at A = 4, B = 3, C = 2, D = 1 and F = 0 grade points per semester hour. With only five rungs, every letter boundary is a full point: miss a B by one question and 3.0 becomes 2.0. UTA publishes grade points, not percentage cutoffs — your syllabus sets the bands. Source: UT Arlington Catalog — Grades and Grading Policies, checked 2026-11-11.

University of Texas at Arlington grading scale — official grade points for every letter from the registrar
University of Texas at Arlington grading scale: every letter and its official grade points. Free to reuse with credit and a link to finalsolver.com.

UT Arlington repeats: below-C only, with Grade Forgiveness

UTA lets you repeat a course only if the earlier grade was below C, and by default both attempts are averaged into your GPA. The escape hatch is Grade Forgiveness: students since Fall 2013 may have up to two D/F grades in 1000/2000-level courses removed from the GPA calculation; earlier cohorts used Grade Exclusion (maximum 3 courses).

Because both attempts average by default, a flat repeat can quietly backfire: retaking a D (1.0) and landing another D leaves twice as many credits parked at 1.0 instead of one clean set. The play at UTA is to reserve repeats for courses you can clearly beat — and if the target is a 1000/2000-level D or F, check Grade Forgiveness first so the old grade is excluded rather than averaged.

What do you need on your final?

Needed = (target − current × (1 − weight)) ÷ weight, where “weight” is your final’s share of the course grade as a decimal. Example: sitting at 85% with a final worth 30% of the grade and targeting 88%, you need (88 − 85 × 0.7) ÷ 0.3 = (88 − 59.5) ÷ 0.3 = 28.5 ÷ 0.3 = 95% on the final.

UTA’s twist: with flat letters only, every boundary between letters is a full grade point — there is no B+ at 3.3 to soften an 89 that reads B here. Find your syllabus’s exact cutoff and aim a couple of points above it, not at it.

University of Texas at Arlington: GPA credits example

Your University of Texas at Arlington GPA is a credit-weighted average: (credits × grade points) summed ÷ total credits. Worked example on the official UT Arlington scale: A (4.0) × 4 credits + B (3.0) × 3 credits + A (4.0) × 3 credits = 16.0 + 9.0 + 12.0 = 37.0 points over 10 credits → GPA 3.70. UTA's table is flat — NO plus/minus grades, no A+: just A = 4, B = 3, C = 2, D = 1, F = 0 per semester hour, so every letter boundary swings a full point. The calculator at the bottom of this page runs this exact table.

Three finals scenarios students actually ask

Static answers, checkable against the calculator above — the three setups that show up every December and May (pass line shown for a typical 70% D; your school's line is in the scale above):

You sit atFinal worthFor a B− (80%)To pass (70%)
85%20%60% — makeable10% — already safe
78%40%83% — study weekend58% — very makeable
60% (bombed the midterm; 30% coursework at 100%)40%80% — a real but winnable fight55% — still passable
Needed = (target − current × (1 − weight)) ÷ weight. An A− from 85% with a 20% final would take 110% — that's the extra-credit conversation, not a study plan. And scenario 3 is why giving up after a bad midterm is usually premature math, not just morale.

University of Texas at Arlington GPA calculator — official scale

Runs this school's exact grade-point table — not a generic 4.0 rounding.

Calculating…

Computed on this school's official grade-point table shown above — no rounding adjustments needed.

Frequently Asked Questions

Does UT Arlington use plus/minus grades?

No. UTA’s official grading table has only A, B, C, D and F — no B+, no A-, no A+ — at 4, 3, 2, 1 and 0 grade points per semester hour.

When can I repeat a course at UT Arlington?

Only if your earlier grade was below C. By default both attempts are averaged into your GPA; Grade Forgiveness (Fall 2013 onward) can remove up to two D/F grades in 1000/2000-level courses, and earlier cohorts used Grade Exclusion with a 3-course maximum.

What is the highest grade at UTA?

A flat A at 4.0 grade points per semester hour. There is no A+ grade and no extra points for it, so 4.0 is the ceiling.

Does a W look bad when I apply to grad school?

One or two Ws read as scheduling realism, not an ability signal — committees weigh trends and course rigor. A pattern of many Ws invites questions, and a W followed by retaking the course (and acing it) often tells a better story than the C you would have survived.

Can I retake a class I got a C in just to boost my GPA?

Not usually the door it looks like: at UT Arlington, repeats require an earlier grade below C — so the C you survived is likely staying. Confirm the exact cutoff in the retake policy above before paying for anything; the cheaper move is usually banking a strong grade in your next course instead of re-buying one you already passed.

More calculators